Marshall cruise to the fountain 2014.
When the project started I was just going to clean up the engine. Well plans change. It started up just fine but was seeping oil out of about every gasket. W... Show morehen torn down we believe it was the first time it had been dismantled. Engine was gone through and professionally rebuilt by Dowkers in Charlotte. Most of the parts to complete the rebuild were supplied by Kanter. It's been bored .20 over. Figured it was never going to be a race car and stock the engine was approximately 330hp. However the carborator is an edelbrock 1406 the points were replaced with electronic ignition via Petronix. Found mooneye finned valve covers. Switched out thermostat housing for big block rotating chevy that could be rotated and had a local machinist custome fab the mount to fit this engine. Eliminated the stock ford overflow jug for a race car style fill and billet overflow bottle. Replaced the alternator with a 1 wire gm model. Eliminated a butt load of vacuum lines to free up the engine a little and clean up the engine compartment. Show Less