Custom Zirgo Electric Fan Mod (in progress........)
The Aluminum Plate I am going to mount the fan to and then mount to the inside of the OEM fan shroud. Th... Show moree inner circle part will be cut out to mount the fan.
My Wiring Diagram with the Two Relays.
My Wiring back to the Relay which is in progress and I am changing things up a bit. I am going to finish adding a second relay into the mix and change the fuse holder.
My Wiring from the Relay onto the Thermostat and Fan wiring.
My Wiring to the Thermostat and Fan (in progress and not finished yet).
The Common Ground Wire connection for the Thermostat and the Fan.
My Switch for the Fans in the Cab.
Latest work (10/2006)..........I finally got some time to work on finishing up the fan shroud mount for the fan. Here is the front side where the fan is going to mount.
Here is the fan shroud mount from the back. I have not yet put a bead of silicone on yet so you can see the minor gaps I had to fill. I almost got the aluminum piece perfect on the inside. It is not 100% round at the point I am mounting the aluminum to the shroud. Show Less
All Clean & Pretty After Bringing it Home from the Dealership!!!
My TRD Exhaust
My Stampede Vigilante LP Hood Protector
The 3M 2228 Tape I used to p... Show morerevent any kind of rubbing (it only touches in one place).
Debadged!! (Texas sun is good for something!!)
Thanks to driving on IH35 I had to have my windshield replaced.........the company that replaced the windshield did a pretty good job on the new windshield (I think....) but also did a good job on f'ing up my dash!!!
View of damage from inside
View of damage from outside Show Less