PROJECT CONTINUES: TUMMY TUCKI am planning to install a high clearance skid plate for my transmission. This will give me an additional 5" of clearance o... Show moren the frame compared to the current with the stock transfer case and a lowering kit. This project will require an SYE, Extended CV driveshaft, Adjustable Control Arms, 1" body lift, 1" motor mount lift and a custom skid plate with a restored 33 Engineering Transfer Case Mounting cross frame and a custom 3/8" aluminum skid removable plate.
With the skid plate complete I am waiting on a few parts before I can finish the install. Now I just need my extended driveshaft and adjustable control arms to arrive to complete the project. Still up in the air on wether or not I will need a body lift. It is a big debate in my head. Show Less
Parts List* Pioneer 10" Subwoofers (2) - - - - $127.00 for both on Ebay* Pioneer 240 WATT AMP (2) - - - - $ 90.00 for both on Ebay* ANL Fuse b... Show morelock (100 AMPS) - - - - $ 16.00 on Ebay* Monster 4 gauge power cable - - - - $ 28.00 on Ebay * Monster 8 gauge power cable - - - - $ 19.00 on Ebay * Speaker Box terminals (2 pairs)- - - - $ 15.00 on Ebay * 4/8 distribution block - - - - $ 5.00 on Ebay * 12 gauge speaker wire - - - - $ 20.00 at Advanced Auto* MDF Boards, screws, caulking - - - - $ 55.00 at Home Depot* Drawer slides for Amplifiers - - - - $ 40.00 at Home Depot* Underbody sound dampening paint - - $ 20.00 at Advanced Auto
TOTAL PRICE FOR PROJECT : $415.00
I think overall I am doing pretty good for the sound quality I got
NEXT AUDIO PROJECTMy next sterio project will be to change out the Infinity speakers that came with the jeep with upgraded PIONEER component speakers (5.25 front, 6.5 overhead). Again it will be tough, but my goal is to disguise all the electronics, so the jeep looks like it could be stock from the outside.
TOTAL PRICE FOR PROJECT : $415.00I think overall I am doing pretty good for the sound quality I got Show Less
This project took me about 3 hours. The hardest part was wiring the lights through the windshield. My windshield had not been dropped in some time and t... Show morehe hinges were quite stiff. For now the lights are wired to the KC switch in recked panel, but in the near future I will purchase some more switches to mount all the wiring into the custom switch board. I am also looking to purchase some KC Rally lights to replace the driving lights I have on the bumper now, just waiting for a new rock bumper first.
AFTER Show Less
EXTERIOR MODIFICATIONSRocker Guards
This project took me about 2 hours. First I removed the existing fen... Show moreder flare extensions and cleaned the painted metal thoroughly. Then I took a 6" rocker guard strip and cut it in half to create two plastic rocker guards. Now I am just waiting to purchase some rock rails to install and finish off the rockers.
AFTER Show Less