This is the dyno pull I made on 1/29/03
Its a little hard to read,the peak H/P was 190 and the T/Q 165. Intake temps were up to 150 at the end of the pull. ... Show moreNext project: WATER INJECTION! I left the A/F ratio rich (~10.8:1) as this is a daily driver with 93000 mile on it and I don't want to push it. More power next time......
Dyno pull from 12/13/06
This is with W/I, cams, rebuilt engine, and about 10psi of boost.
Best 1/8th mile run is a firstname.lastname@example.orgMPH. It did a 2.175 60' time on street tires.
New best 1/8th mile time of email@example.comMPH. 60' was a 2.145
1/4 mile run is at firstname.lastname@example.orgMPH, 60' was a 2.164
The newst addition is my hood scoop. I molded in a WRX scoop, which is fully functional. It draws air in over the blower when moving and acts as a vent sitting still. You can see the blower in the hood scoop on the bottom pic.
Finally finished the exhaust system. The last part was the 2.125" collector on the header.This was also a slip fit joint. I chopped that off and added a new piece of 2.5"pipe as well as the 2.5" flex joint. Now its flanged to the Thrush glasspack resonator. The whole system is 2.5", all bends are mandrel bent.
Take a ride?(6/23/03)
See a race?(6/24/03)
http://www.turbosaturns.net/video/grudgematch.mpg Show Less