Home > Brands > Vortech Superchargers
A&A V3 Si-Trim Supercharger kit
Vortech Supercharger V-2 S Trim
Built new 383 with SCAT 4340 Forged Crank, SCAT 6" H-Rods, Diamond Pistons, AFR 220 Heads, Crower Custom grind Cam, Crower 1.6 ratio Shaft Rockers, Earle Williams 1.75" headers, QuickFuel 750DP-BAN carb, Edelbrock Victor JR, MSD Pro-Billet, Trans Magic TH400 with B&M Kit, Wenco 3.5" Aluminum Driveshaft with 1350 Joints ...
Installed by:Pro Installer
There is alot that goes into installing a Supercharger amongst all the additional parts that are needed in order to make it run. So if your planning on doing this kind of install be prepared to fork out some time and money! but it the end it is worth it! ...
it was a little difficult,but after read and read and read the manual
The install was not as straight forward due to the large modifications done to the car, But Realspeed always finished the job top notch.
This part is very easy to instal, It's taking me much longer though because I have to make the parts to put it on my car because it was never intended for my vehicle... I am looking forward to seeing the Hp and Tq gains
2.75 pulley. 17 psi boost.